   |
 |
| The 20mm Thru-Axle Front Hub |
| | ||||||||
| ISO 20mm Thru-Axle Front Disc Hub | |||||||||
| |||||||||
This design was a challenge. As with all of our products, we wanted the 20mm Thru-Axle Front Disc Hub to be the best that money could buy. Our design criteria were simple: a one piece super strong axle that could be adjusted in the field with a single wrench, without removing the wheel, the toughest bearings possible and it needs to build an excellent wheel while still looking sharp and not weigh in like a stuffed pig. We had to design an entirely new bearing for this guy. It is about the same size as a one inch headset bearing. Bigger than anything else out there. A high strength, 110mm, one piece aluminum axle is capped with 2 stainless steel axle  biters to hold onto your fork legs like crazy. Why a one piece axle? Some other hubs require that you adjust the hub bearings by clamping the fork legs together harder, while others have no adjustments at all. You want strong? Looking for reliability and ease of adjustment? Look no further. The 20mm Thru Axle Front hub is compatible with the ISO disc standard, available in all of our colors, in 32° and 36°. | |||||||||
Our new ISO 150 Disc rear hub brings the time-tested reliability and performance of Chris King hubs to downhill and heavy-duty freeride bikes featuring 150mm x 12mm thru axle rear dropouts. These big bikes get into some serious situations but it's no concern for the ISO 150 Disc hub. This isn't a "new" hub, it's another great hub from King. Same performance. Same durability. Same expectations. 
As with all Chris King hubs, the ISO 150 is completely user serviceable. Bearing preload can be adjusted without removing the wheel using a 2.5 hex-head wrench to fine-tune the adjusting clamp on the non-drive side. Thorough service can be performed on the hub bearings using a 2.5 hex-head wrench and penknife while our